N-Trak Tips

Masonite Clamp Pads

by

Steve Gillett

As we all know, N-Trak modules are connected in place by pairs of C-Clamps that tighten and hold the modules’ side fascia boards to each other. Over time, the clamping and re-clamping can damage the fascia boards, causing compression, splintering and cracking of the wood.

A simple fix for this problem is to cut 3 ¼” x 3 ¼” squares of 3/16” Masonite hardboard and glue them to the inside of the side fascia boards where the clamps will go. The Masonite is very hard and will not compress or be damaged if a C-clamp is over-tightened. If for some reason it is damaged, just pop it off and glue a new one in its place.

While you’re cutting the Masonite squares, make a bunch of extras. They are perfect to use as shims if you are setting up a layout on carpet or on an uneven floor and you can’t extend the leg screws far enough!